| |
CH538-67065
Upper left support sensor with cable - For the Designjet T series printers
|
RF5-3508-020CN
Door hinge support - Mounts on the upper left corner on the front of the print engine frame
|
RC1-1159-000CN
Right front cover rod support - Attaches above front cover hinge on right side - Attachment point for belt drive disengagement rod on right side
|
C2693-67049
Right support assembly - Supports the right side of the print mechanism and the service station assembly
|
|
|
RF5-2701-060CN
Access door struts - Attached to each side of diverter door assembly
|
RC1-2856-000CN
Cartridge support - Lower toner cartridge support - Located in upper plate assembly
|
|
|
RG1-1793-000CN
Roller support - Supports left hand side of transfer roller
|
RG5-6510-000CN
Control panel crossmember assembly - Supports control panel
|
CR651-67007
Upper right roll cover support (Carbonite Black) - Located on the upper right side of the Designjet
|
RL1-0217-000CN
Gear support - Pickup roller drive gears support - Piece that the 43 tooth and 27 tooth gears are mounted to on lower right front of printer
|
RF5-3506-020CN
Door hinge support - Mounts on the upper right corner on the front of the print engine frame
|
RC1-1036-000CN
Separation pad support - Pivoting L shaped metal support frame (Does NOT include the separation pad assembly)
|
RG5-6460-000CN
Paper cassette frame - Right side Tray 2 support frame assembly
|
|
|
|
|
C4723-60290
Electronics support frame and cover supports - Includes the support located above the refill interconnect cable and the two supports used to mount the rear cover
|
RC1-6668-000CN
Upper support cover - This is black plastic under the sheet metal that is under the fuser
|
RG5-6107-020CN
MP Tray/Tray 1 rear support assembly - Tray 1 right side support
|
|
|
|
|
RG5-7523-000CN
Outrigger stabilizer assembly - Side stabilizer leg with adjustable foot - Six used
|
RG5-7631-000CN
Right support assembly - Metal frame which supports the top mounted scanner and the camera (photo) memory interface board assembly - Also includes the scanner release button/lever
|
Q6651-60264
Stand supports - For the DesignJet Z6100 printer series
|
RB2-3503-000CN
Shaft holding block - Front registration roller support
|
RL1-0436-000CN
Damper support - Metal support bracket that attaches to printer chassis that supports bottom of gas damper
|
RB2-5407-000CN
Support extension - Attaches to end of document output wire
|
|
|
|
|
|
|
RB2-9963-000CN
Separation pad support - Pivoting 'L' shaped metal support frame (Does NOT include the separation pad assembly)
|
|
|
RB2-5437-000CN
ADF input tray - Automatic Document Feeder input support
|
C3190-40026
Control panel support - will come with control panel and support.
|
|